The P265GH Boiler Plate Grade That Still Holds 265 MPa at Temperature

The P265GH Boiler Plate Grade That Still Holds 265 MPa at Temperature

Most steel plate is bought on room-temperature yield strength. Boiler and pressure-vessel plate is bought on a harder question: how much strength is left after ten years at 350 °C. P265GH is the grade European designers reach for in that situation, and it is one of the most widely specified plates in steam, hot-water and process duty.

EN 10028-2 compresses the whole specification into the name. P stands for pressure purposes. 265 is the minimum yield strength in MPa at room temperature for plate up to 16 mm thick. GH confirms that the grade carries verified properties at elevated temperature, and that is what separates it from a structural plate of similar strength. Chemistry is held tight: carbon 0.20% maximum, manganese 0.80-1.40%, phosphorus 0.025% maximum, sulphur 0.010% maximum, with a carbon equivalent no higher than 0.40.

P265GH ships in the normalized condition. The plate is rolled, reheated above the austenitizing range and air cooled, which refines the grain and evens out properties through the full thickness. That is what makes the Charpy impact test at 0 °C meaningful rather than decorative: a normalized P265GH plate has a toughness profile you can design against, not one that shifts with the rolling schedule.

A carbon equivalent of 0.40 or below keeps P265GH inside normal shop practice. Under about 30 mm, most fabricators weld it without preheat using matching consumables; heavier sections and high-restraint joints generally call for 100-150 °C preheat. The low sulphur limit also reduces susceptibility to solidification cracking in the weld pool, which matters on nozzle and manway details where the joint is thick and heavily restrained.

Buyers often ask whether P265GH can replace ASTM A516 Gr.70. On paper they are close but not identical: A516 Gr.70 requires 485-620 MPa tensile with 260 MPa minimum yield, while P265GH sits at 410-530 MPa tensile with 265 MPa yield. A516 Gr.70 is the stronger plate, P265GH the more ductile one, and its lower carbon equivalent suits fabricators who want to avoid preheat. Against S355J2+N structural plate, P265GH adds tabulated design values up to 400 °C plus much tighter phosphorus and sulphur limits.

We cut P265GH to length from 6 mm to 60 mm to your nesting plan, with EN 10204 3.1 or 3.2 certification. Plates can be supplied normalized, ultrasonically tested to EN 10160 where the specification calls for it, and third-party inspected before shipment. The same plate feeds our storage tank and tank head lines, so mixed thicknesses and smaller quantities are workable rather than a special favour.
If your next boiler, heat exchanger or LPG sphere project calls for P265GH, send the thickness list and the drawing. We will confirm mill availability, delivery condition and the certificates that travel with the plates.